The wire drawing of the 1060 aluminum plate should be done after stamping. The wire drawing can be made into straight grain, random grain, thread, corrugation and swirl according to the needs of decoration.

Straight grain drawing refers to processing straight lines on the surface of the 1060 aluminum plate by mechanical friction. It has the dual function of brushing off scratches on the surface of the aluminum plate and decorating the surface of the aluminum plate. There are two kinds of straight wire drawing: continuous wire grain and intermittent wire grain. The continuous silk pattern can be obtained by rubbing the surface of the aluminum plate continuously horizontally and straightly with a scouring pad or a stainless steel brush (such as manual grinding under the condition of a current device or using a planer to clamp a wire brush on the aluminum plate). By changing the diameter of the steel wire of the stainless steel brush, different thicknesses of lines can be obtained. Intermittent silk patterns are generally processed on a brushing machine or a wiping machine. Preparation principle: Two sets of differential wheels rotating in the same direction are used. The upper set is a fast-rotating grinding roller, and the lower set is a slow-rotating rubber roller. The aluminum or aluminum alloy plate passes through the two sets of rollers and is brushed out. Delicate interrupted straight lines.

Random wire drawing is a kind of irregular and non-obvious matte silk pattern obtained by moving the aluminum plate back and forth, left and right, and rubbing under the high-speed copper wire brush. This kind of processing has higher requirements on the surface of the aluminum or aluminum alloy plate.

The corrugation is generally produced on a brushing machine or a wiping machine. Using the axial movement of the upper set of grinding rollers, the surface of the aluminum or aluminum alloy plate is brushed to obtain a wave pattern.

Spin pattern, also known as optical rotation, is a kind of silk pattern obtained by rotating and polishing the surface of aluminum or aluminum alloy plate by using cylindrical felt or nylon wheel for grinding stone on a drilling machine, mixing polishing ointment with kerosene. It is mostly used for decorative finishing of circular signs and small decorative dials.

The thread is a small motor with a circular felt on the shaft, which is fixed on the table at an angle of about 60 degrees to the edge of the table. A strip of mylar with straight edges is attached to limit thread race. Using the rotation of the felt and the linear movement of the carriage, a thread pattern with the same width is rubbed on the surface of the 1060 aluminum plate.